Main content

This entry is from Winter semester 2018/19 and might be obsolete. No current equivalent could be found.

Computer Aided Geometric Design
(dt. Computer Aided Geometric Design)

Level, degree of commitment Specialization module, compulsory elective module
Forms of teaching and learning,
workload
Lecture (3 SWS), recitation class (1 SWS),
180 hours (60 h attendance, 120 h private study)
Credit points,
formal requirements
6 CP
Course requirement(s): Oral examination
Examination type: Successful completion of at least 50 percent of the points from the weekly exercises.
Language,
Grading
German,
The grading is done with 0 to 15 points according to the examination regulations for the degree program M.Sc. Mathematics.
Duration,
frequency
One semester,
Regularly alternating with other specialization modules
Person in charge of the module's outline Prof. Dr. Stephan Dahlke

Contents

Practical methods for the representation of curves and surfaces, such as Bezier polynomials and splines, surface representations with tensor products and triangular decompositions.


Qualification Goals

The students shall

  • recognize that non-mathematical requirements, such as manageability, can influence the selection of function classes in practical use,
  • learn to recognize and assess the relevance of computer graphic methods for practical problems, e.g. in engineering, and to acquire the tools to solve these problems,
  • to recognize the relations of CAGD to other areas of mathematics, such as numerical analysis or differential geometry,
  • practice mathematical working methods (development of mathematical intuition and its formal justification, training of the ability to abstract, proof techniques),
  • improve their oral communication skills in the exercises by practicing free speech in front of an audience and during discussion.

Prerequisites

Translation is missing. Here is the German original:

Keine. Empfohlen werden die Kompetenzen, die in den Basismodulen und im Aufbaumodul „Numerik“ (Numerische Basisverfahren) vermittelt werden.


Applicability

Module imported from M.Sc. Mathematics.

It can be attended at FB12 in study program(s)

  • B.Sc. Mathematics
  • B.Sc. Business Mathematics
  • M.Sc. Computer Science
  • M.Sc. Mathematics
  • M.Sc. Business Mathematics

When studying M.Sc. Computer Science, this module can be attended in the study area Minor subject Mathematics.


Recommended Reading

  • Barnhill, R.E., Riesenfeld, R.F.: Computer Aided Geometric Design, Academic Press;
  • Farin, G.: Curves and Surfaces for Computer Aided Geometric Design: A Practical Guide, Academic Press.



Please note:

This page describes a module according to the latest valid module guide in Winter semester 2018/19. Most rules valid for a module are not covered by the examination regulations and can therefore be updated on a semesterly basis. The following versions are available in the online module guide:

The module guide contains all modules, independent of the current event offer. Please compare the current course catalogue in Marvin.

The information in this online module guide was created automatically. Legally binding is only the information in the examination regulations (Prüfungsordnung). If you notice any discrepancies or errors, we would be grateful for any advice.